Ys9082hp: Mptool

If your SSD using the Yeestor YS9082HP controller has stopped being detected or shows as a 2GB "ROM MODE" drive, you can often revive it using the MPTool (Mass Production Tool) firmware flasher. Guide: Repairing Your SSD with YS9082HP MPTool Identify Your Hardware Confirm your controller is a Yeestor (SiliconGo) YS9082HP by opening the SSD casing. NAND Flash type

Step 4: Start the Flashing Process

  1. Click Start or Begin MP.
  2. The tool will:

    Red Circle/Fail: This usually indicates physical NAND failure that firmware cannot fix. Troubleshooting Common Errors ys9082hp mptool

    Error 2: "Bad Block count > Limit"

    Meaning: The NAND flash has physically worn out. The controller refuses to format because there are too many dead cells. Fix: Under "Parameter" -> "Special," check "Force Erase Bad Blocks" . Note: This will shorten the drive's remaining life but may recover it for temporary use. If your SSD using the Yeestor YS9082HP controller

    The YS9082HP MPTool is a specialized mass production (MP) firmware flashing utility developed by Yeestor (formerly SiliconGo). It is primarily used for the "opening" (initialization), repairing, and reprogramming of SATA SSDs that utilize the Yeestor YS9082HP controller. Core Functions and Purpose Click Start or Begin MP

Retour
Haut