Xh-m608 Manual Verified 💫

Based on the typical naming conventions for industrial electronics, the XH-M608 is most commonly identified as a DC Motor Speed Controller (PWM) or a DC-DC Step-up/Down Converter Module.

1. Power Input (Power Source):

   P (Protection): Relay stays closed only when the voltage is between the lower (P1) and upper (P2) limits. Xh-m608 Manual

   The XH-M608 Battery Charge and Discharge Module is a versatile digital control board used for protecting batteries from over-charging and over-discharging within a range of DC 6-40V. Primary Operating Modes (P0 Settings) Based on the typical naming conventions for industrial

   1. Press the rotary encoder firmly for 3 seconds to enter the menu.
   2. Use the twist function to find P-2 (Pulse 2 time).
   3. Set this to a higher value than Pulse 1. Example: P-1 = 2.0 ms / P-2 = 4.0 ms.
   4. Find Int (Interval). Set the delay between pulses to 10 ms – 20 ms.
   5. Press the encoder to save.
   • No Sound: Check power supply, input connections, and volume settings.
   • Distorted Sound: Check for overload, incorrect gain settings, or faulty connections.
   • Model: XH-M608
   • Power Supply: DC 5V-12V
   • Output: 2 Channels, e.g., 2x 10W (This can vary)
   • Frequency Response: Typically 20Hz-20kHz
   • THD (Total Harmonic Distortion): A specific value indicating the level of distortion

   4. Programming the Parameters

   The board has two user-set voltage thresholds: Power Input (Power Source): P (Protection): Relay stays

   Troubleshooting Common Issues