V2000-c User Manual !!exclusive!! -

The V2000-C is primarily a standalone RFID access control keypad supporting 500-1,000 users, 125KHz RFID cards, and 4-digit PINs, often in a waterproof housing. It is powered by 12V DC and features multiple entry methods, including card-only, PIN-only, or combined card and PIN. For the full manual, visit obohands.com

V2000-C User Manual

Version 1.0
For models: V2000-C (Standard), V2000-C Pro v2000-c user manual

acts as the "brain" for your door. You will typically need to connect it to: Power Supply The V2000-C is primarily a standalone RFID access

: If you forget your master code, look for the "Hard Reset" jumper on the back of the circuit board to return to factory settings. Conclusion Format your card every 2–4 weeks in the

Q: Can I use a 512GB SD card?
A: The manual says “up to 256GB,” but some firmware v2.3+ units support 512GB exFAT. Test with a known brand (SanDisk Extreme Pro). If the camera reboots, revert to 256GB.

7. Maintenance Tips

• Format your card every 2–4 weeks in the camera (not PC) – prevents corruption.
• Check for firmware updates – search “V2000-C firmware” + your brand name.
• Clean lens gently with microfiber cloth.
• Don’t leave in direct summer sun for hours – heat kills batteries.

Readers: Wire your Wiegand or OSDP readers to the Reader 1 and Reader 2 ports.