Simrad Rf300 Installation Manual
The Simrad RF300 is a medium-duty rotary rudder feedback unit designed specifically for boats with inboard engines. It provides high-resolution data to your autopilot system, ensuring smooth, accurate steering by determining the precise angle of the rudder. Mounting Instructions
: Mount the RF300 on a flat platform where the center of the unit is in line with the center of the rudder post. Mechanical Linkage simrad rf300 installation manual
- Mounting location: Choose a location on the hull or transom that is free from obstructions and provides a clear path for the sonar signal. Avoid areas with turbulence or aeration, such as near propellers or drain holes.
- Transducer orientation: Ensure the transducer is properly oriented to match the boat's hull and propeller configuration. The transducer should be pointing downwards, parallel to the keel, and aligned with the centerline of the boat.
- Secure mounting: Use the provided mounting hardware to secure the transducer to the hull or transom. Make sure the transducer is firmly attached and will not move or shift during operation.
- Adjust for deadrise: If your boat has a deadrise angle, adjust the transducer accordingly to ensure proper alignment.
Wiring: The unit typically uses a brown wire (terminal 11) and a white wire (terminal 12) for connection. The Simrad RF300 is a medium-duty rotary rudder
5. Configuration and Calibration
Once the mechanical installation and wiring are complete, the autopilot system must be calibrated to recognize the RF300. Mounting location : Choose a location on the
Post-Installation Procedures:
Polarity: While it is a two-wire system, always follow the specific wiring diagram in your autopilot computer manual to ensure the frequency signal is correctly interpreted.