Onkyo Rc-799m Remote Manual May 2026

Direct Answer First You can easily download and use the official Onkyo RC-799M remote manual to program your device and control your home theater system. This guide provides codes and setup steps. Introduction

Press and hold the [REMOTE MODE] button (like TV) and [DISPLAY] simultaneously for about 3 seconds until the button stays lit. onkyo rc-799m remote manual

Conclusion: Why the RC-799M Still Matters

In a world of Bluetooth and Wi-Fi smartphone apps, the Onkyo RC-799M remains a remarkably capable piece of engineering. It offers tactile feedback, instant response times, and universal control without needing an app update or a Wi-Fi password. By mastering this Onkyo RC-799M remote manual, you can resurrect a "dead" remote, program it to control a modern 4K TV, and even automate your movie-watching routine with macros. Direct Answer First You can easily download and

• Place the original device remote and RC-799M head‑to‑head.
• Enter learning mode (press SETUP, then the learning command).
• Press the source button on the RC-799M, then the corresponding button on the original remote to copy the IR signal.
• Repeat for each button to be learned, then exit learning mode.

Features:

1. Press and hold the desired MODE button (e.g., TV) and press ENT.
2. Enter the 4-digit code.
3. Test the power function to verify success.

Point the remote at the device and press the Power (or On/Standby) button. If the device turns off, programming is successful.

Repeat the process for each device (DVD, CBL/SAT, etc.).

Onkyo RC-799M Remote Manual: A Complete Guide to Programming and Troubleshooting

If you own an Onkyo home theater receiver from the late 2000s or early 2010s—such as the TX-SR607, TX-SR578, or HT-RC160 models—you’re likely holding the RC-799M remote control. It’s a sleek, fully-featured universal remote, but finding the original printed manual can be a challenge. Features:

Using On‑Screen Menus (Receiver-dependent)

• Press MENU or HOME to show the receiver’s interface on your TV.
• Use arrow keys to navigate: Speaker setup → Input assign → Network setup → Audio settings.
• Press ENTER to select and BACK to return.
• Use INFO to display current input and DSP mode.