Dlc V21 Manual Link - Makerbase Mks

The Makerbase MKS DLC v2.1 is a specialized control board designed for desktop CNC and laser engraving machines, typically utilizing the ATMEGA328P microcontroller to run GRBL firmware. Note that this model is distinct from the 32-bit MKS DLC32 series, though they share similar naming conventions. 🛠️ Core Documentation Links

MKS-DLC/hardware/MKS DLC V2. 1_001/MKS DLC V2. 1_001 PIN. pdf at master · makerbase-mks/MKS-DLC · GitHub. MKS DLC V2.1_001 SCH.pdf - GitHub makerbase mks dlc v21 manual link

Troubleshooting

• Connectivity Issues: If the device doesn't connect properly, check all cables and ensure the software is correctly configured.
• Display Issues: If the screen doesn't work as expected, ensure it's properly powered and consider updating the firmware.

Once connected via USB (usually at 115200 baud rate), you may need to adjust these settings in the console: $100, $101, $102: Steps per mm for X, Y, and Z. $32=1: Enable Laser Mode (if using a laser). The Makerbase MKS DLC v2

The Makerbase MKS DLC v2.1 is a high-performance control board designed for desktop CNC machines and laser engravers. It is widely recognized as a major upgrade over traditional 8-bit Arduino-based controllers due to its use of the ESP32 32-bit microcontroller, which provides integrated Wi-Fi, Bluetooth, and significantly faster processing speeds. Official Manual and Resource Links Connectivity Issues : If the device doesn't connect

Are you planning to use this board for a laser engraver or a CNC router project? MKS DLC V2.1_001 PIN.pdf - hardware - GitHub