"Если бы я был рок или поп-звездой, я бы сейчас думал, как я выгляжу…"
Chris Rea
Гитарист, певец, актер
Цитата Криса Ри
Крис Ри
Музыкальный мир
Creality V2 2 Board Diagram ~upd~
Creality V2.2 Motherboard (also referred to as the V2.2.1) is an 8-bit mainboard commonly found in printers like the Ender 5 Plus
4.3 Thermistors (Analog inputs)
| Sensor | MCU ADC Pin | Reference voltage | |--------|-------------|-------------------| | Hotend | PA2 (ADC2) | 3.3V (via 4.7k pullup to 3.3V) | | Bed | PA3 (ADC3) | 3.3V (via 4.7k pullup to 3.3V) | Creality V2 2 Board Diagram
Overall Rating: 3.5/5 (averaged)
Bottom line:
If you own a Creality V2.2 board, do not rely on Creality’s official diagram alone. Instead, print a community-corrected pinout and tape it inside your printer’s electronics case. The board itself is decent for silent printing, but its documentation is a weak link—saved only by passionate open-source contributors. Creality V2
4.6 LCD Interface (EXP1 / CN3 – 10‑pin)
This is a standard CR‑10 / Ender 3 display using SPI (ST7920). Calibration: The "Paper Test" Six dedicated ports for
via a ribbon cable. Most auxiliary components (fans, sensors, leveling probes) plug into this breakout board rather than the mainboard directly. Calibration: The "Paper Test"
Six dedicated ports for X, Y, Z (dual), and E (dual) axis motors.
Creality V2.2 Motherboard (also referred to as the V2.2.1) is an 8-bit mainboard commonly found in printers like the Ender 5 Plus
4.3 Thermistors (Analog inputs)
| Sensor | MCU ADC Pin | Reference voltage | |--------|-------------|-------------------| | Hotend | PA2 (ADC2) | 3.3V (via 4.7k pullup to 3.3V) | | Bed | PA3 (ADC3) | 3.3V (via 4.7k pullup to 3.3V) |
Overall Rating: 3.5/5 (averaged)
Bottom line:
If you own a Creality V2.2 board, do not rely on Creality’s official diagram alone. Instead, print a community-corrected pinout and tape it inside your printer’s electronics case. The board itself is decent for silent printing, but its documentation is a weak link—saved only by passionate open-source contributors.
4.6 LCD Interface (EXP1 / CN3 – 10‑pin)
This is a standard CR‑10 / Ender 3 display using SPI (ST7920).
via a ribbon cable. Most auxiliary components (fans, sensors, leveling probes) plug into this breakout board rather than the mainboard directly. Calibration: The "Paper Test"
Six dedicated ports for X, Y, Z (dual), and E (dual) axis motors.